Infrared Hygrometer: Difference between revisions

From Saltwiki
Jump to navigation Jump to search
(Created page with "Author: Hans-Jürgen Schwarz<br> <br> English Translation by Sandra Leithäuser<br> <br> back to [[Air Humidity Measurement|Air Humidity ...")
 
No edit summary
Line 5: Line 5:
<br> back to [[Air Humidity Measurement|Air Humidity Measurement]] <br>
<br> back to [[Air Humidity Measurement|Air Humidity Measurement]] <br>


{{underConstruction}}
<!--


== Abstract  ==
== Abstract  ==
Line 18: Line 16:


== Literature ==
== Literature ==
-->
<biblist/>
 
[[Category:Humidity Measurement]] [[Category:Schwarz,Hans-Jürgen]] [[Category:R-SLaue]] [[Category:inProgress]]
[[Category:Humidity Measurement]] [[Category:Schwarz,Hans-Jürgen]] [[Category:R-SLaue]] [[Category:inProgress]]

Revision as of 07:51, 29 October 2012

Author: Hans-Jürgen Schwarz

English Translation by Sandra Leithäuser


back to Air Humidity Measurement


Abstract

Water has distinct absorption bands in the infrared light spectrum. The absolute humidity of gases can be detected without delay, by measuring the optical absorption. Due to the infrared gas analyzers, this process is relatively expensive. However, at moderate humidity levels it quickly delivers results at a high reproducibility.

Operating mode:

An object is irradiated by an infrared light source, through a filter. The filter produces a light signal at wavelengths of 1.93 µm and 1.7 µm. Water has the property to absorb light at wavelengths of 1.93 μm. The light reflected by the sample is lead to a photo-resistor, which converts it into an intensity-dependent signal. The light intensity depends on the moisture content of the sample. In order to be independent of the reflectivity of the solid material, another signal is processed at a wavelength of 1.7 µm, and then the ratio of both signals is formed.


Literature

There were no citations found in the article.